Juno JKI4063 Bedienungsanleitung Seite 8

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 10
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 7
8
GerŠt in die Nische einschieben bis die
Anschlagleiste (A) unten am Mšbel anliegt.
A
D022
Montageanleitung fŸr den
integrierten Einbau
Nischenma§e
Modell JKI 4053 JKI 4063
Hšhe 1030 mm 1225 mm
Tiefe 550 mm 550 mm
Breite 560 mm 560 mm
Aus GrŸnden der Sicherheit mu§ eine
MindestbelŸftung gesichert sein, wie aus der
Abb.hervorgeht.
Achtung: Die Ventilations - …ffnungen mŸssen
immer saubergehalten werden.
Ferner ist auch am hinteren Einbauschrankteil ein
LŸftungskamin mit filgenden Massen notwendig:
Tiefe 50 mm
Breite 540 mm
50 mm
min.
cm
2
200
200 cm
2
min.
D567
TŸranschlagwechsel
Zur Transportsicherung wurde die GerŠtetŸr an
beiden Anschlagseiten mit Scharnierstiften befestigt.
Je nach TŸranschlag, Scharnierstift auf einer Seite
oben und unten entfernen.
PR01
540
50
B
T
H
Fugenabdeckprofil am GerŠt, wie in Abbildung
gezeigt ankleben.
D765
13
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be placed at different heights.
To make these adjustments proceed as follows:
Gradually pull the shelf in the direction of the arrows
until it comes free, then reposition as required.
Movable shelves
The walls of the refrigerator are equipped with a
series of runners so that the shelves can be
positioned as desired.
For better use of space, the front half-shelves can lie
over the rear ones.
D338
D741
PR189
Bottle holder
The bottle holder hooked onto one of the internal
shelves can be used to store bottles or cans. To
remove this holder, lift the back of the shelf, press
and pull it out. Slide the holder out and refit the
shelf.
Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
¥ room temperature;
¥ how often the door is opened;
¥ the quantity of food stored;
¥ location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
Fresh food refrigeration
To obtain the best performance:
¥ do not store warm food or evaporating liquids in
the refrigerator;
¥ do cover or wrap the food, particularly if it has a
strong flavour.
¥ Position food so that air can circulate freely round it.
Seitenansicht 7
1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare