Juno JDK7940E Bedienungsanleitung PDF herunterladen (Seite 5)

10

to regulations with an opening distance

between contacts of not less than 3mm.

The manufacturers are not liable for any

problems caused by the user’s failure to

observe the above instructions.

Mounting of hood

a. Fit the drilling scheme onto the wall at the

right height.

The lower edge of the scheme correspond

to the lower edge of the cooker hood.

b. On the drilling scheme is printed a line

corresponding to the centre of the

appliance; with a pencil draw a line up to

the ceiling, this will aid installation

procedures (Fig. 3).

c. Drill as indicated on the scheme and fit

two dowels, two hooks and two screws

5x45 (Fig. 3).

d. Hang the hood, adjust the position using

the screws on the hooks of the hood

(Fig. 4).

e. Release the grease filters (Fig. 1).

f. From the inside of the hood mark on the

wall the point corresponding to the hole

which will be used to fix definitively the

hood (Fig. 5).

g. Remove the hood.

h. Drill two hole (Ø 8mm) and fit two dowels.

i. Hang the hood again on the hooks.

j. From inside of the hood insert the

definitive fixing screws (Fig. 5).

k. Dismount the chimney support "c" from

the chimney unscrewing the two side

screws (one per side of the chimney-

conserve them) (Fig. 6).

Dismount the deflector "b" from the

chimney support unscrewing the two

screws that fix the deflector to the chimney

support (conserve the screws) (Fig. 6).

Fit the chimney support "c" onto the wall

close to the ceiling.

The support has a reference mark, this

must match the line previously drawn on

the wall (Fig. 6).

Mark with a pencil the hole to be done

and drill the holes (Ø 8mm).

Insert two wall dowels and fix the

telescopic chimney support with two

screws 5x45 (Fig. 6).

The power plug must be disconnected

from the mains during the mounting

procedure.

Exhausting version

l. Fit a Ø 150 mm exhausting pipe or flex

tube on the hood outlet on top of the

motor housing and connect it to the wall

or roof outlet pipe.

Recirculating version

m.If not already fitted, fit the connection ring

(a - Fig. 6) supplied (bajonett attachment

- turn clockwise and fix with a screw) on

the deflector "b".

n. Insert the deflector "b" in the chimney

support "c" and fix it with two screws

(Fig. 6).

o. Fit a Ø 150 mm exhausting pipe on the

motor outlet connection ring "a"

sufficiently long to reach the connection

ring on the deflector.

For both versions:

p. Now connect the power plug to the wall

outlet.

q. Fix the chimney top part on its support

with two screws (Fig. 6).

r. Slide the lower section of the chimney

downwards and insert it on its proper

housing on the upper side of the hood

(Fig. 6).

s. Refit the grease filters

GB

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare